1. Strictly implement the operating procedures to achieve no-load starting and no-load parking; ensure continuous and uniform feeding.
2. Various technical parameters of the screw conveyor should be selected reasonably. If it is a slow screw conveyor, the rotation speed should not be too large.
3. It is necessary to increase the discharge port or lengthen the end of the trough to solve the problem of poor discharge and late discharge. At the same time, a small section of counter-rotating blades can also be installed at the end of the feed slot to prevent the end from blocking the material.
4. Open an anti-blocking valve on the discharge end cover plate. If there is a blockage, it is due to the accumulation of materials, open the anti-blocking door, and cut off the power supply through the travel switch.
5. The materials entering the conveyor must be cleaned up to prevent large impurities or fibrous impurities from entering the machine and causing blockage.
6. The lateral size of the intermediate suspension bearing should be reduced as much as possible to reduce the possibility of material blocking when the material passes through the intermediate bearing.
7. When installing the silo leveler and clogging sensor, automatic control and alarm should be realized.
https://www.stordworkshop.com
